How do I apply an EZINK tattoo?Updated 2 months ago

Step 1: Moisturise 1-2 hours before the prepping starts

Step 2: Pick a time when you can stay relatively still for 15–20 minutes and keep the tattoo dry for the first few hours after applying.

Step 3: Prep your skin properly (this is everything)

• Shave the area (even if you have light hair)
  Hair stops full contact and causes gaps and lifting.
• Use the primer wipes provided
  Wipe the full area and let it dry fully. This helps remove oils and improves adhesion.
  

Step 4: Remove the tattoo from its plastic & peel the clear protective film off

Step 5: Position & place the tattoo

•  Keep the paper slightly lifted as you place, so it doesn’t stick too early
•  Avoid creases - If it starts to wrinkle, lift gently and reposition before wetting.
  

Step 6: Apply water evenly

•  Use a damp cloth and press firmly onto the backing
•  Keep steady pressure across each section. Work from top to bottom in overlapping sections.
•  Make sure every part gets equal attention. Tattoos fail when some areas stay “too dry” and don’t transfer.
  

Step 7: Check the backing before you peel. You want the backing paper to look fully saturated and slightly softened. If it still feels stiff/dry in spots, keep pressing with the damp cloth.

Step 8: Peel the backing off slowly

•  Peel from one corner slowly
•  If any part is lifting or sticking to the paper, stop immediately. Press that area again with the damp cloth and wait a little longer, then continue.

Step 9: First 6–8 hours after application (this period matters a lot)

•  Keep it dry
•  Avoid sweating heavily
•  Avoid scrubbing or scratching the design
  

Step 10: Aftercare for best results (next 24–48 hours)

•  Do not moisturise while the tattoo is developing
•  Avoid scrubbing the area in the shower
•  Pat dry, don’t rub
•  Avoid exfoliating products on the tattoo area

Want to watch a video? Watch how to apply here: